Checkpoint Slope Pins # 1301

*Laser level not included

Checkpoint Slope Pins # 1301

The Scope Pins attach under either end of Checkpoint Mag Base’s or 3D DMS Professional Level as indicated on the base sides and are held in place by the neodymium magnets centered on the flat side. They give exact slopes or grades with no calculation depending on your choice of slope pin size. For example, simply place a 1/4” slope pin at the front or rear location of the Stubby or Magnum base, and the 880 will project an exact 1/4” per foot rise or fall depending on the location of the pin (+ or -). Slope Pins are sold either individually or in sets of seven pieces, and come in 1/16” increments (starting with 1/8” slope). Again, each will work with Stubby and Magnum Bases and the 3D DMS Series Professional Level.

Slope pins are sold in a set of 7 pieces with case and lanyard in 1/16” increments. The sizes are as follows:

American (#1301): 1/8”, 3/16”, 1/4”, 5/16”, 3/8”, 7/16”, 1/2"
Metric (#1304): 10mm, 20mm, 30mm, 40mm

Checkpoint Slope Block # 1305

*Laser level not included

Checkpoint Slope Block # 1305

Attaches to our brass adapter that screws directly into the front aperture of our Checkpoint Level line. The Slope block gives you exact slopes or grades with no calculation. Depending on your choice of slope, all you need to do is just turn the Slope Block to the setting you need. For example, turn the Slope Block to 1/4” slope and the laser level will project an exact 1/4” per foot rise. Our Slope Block system has 3 settings; 1/8”, ¼” and ½”. Every Slope Block is precisely machined from billet aluminum and has an aircraft anodized finish and fully laser engraved with all markings.

The sizes are as follows:

American (#1305): 1/8”, 1/4”, 1/2" Metric (#1306): 10mm, 20mm, 30mm.