|
|
|
|
|
|
| FREE SHIPPING - On orders over $250 - Applies to UPS Ground Only (No Common Carrier) - Click here for details |
|
|
|
| Installation & Operating Instructions: | |
| The EnrtyWay system includes: (1) Inside Unit, (1) Outside Unit, (1) 9-Volt Heavy Duty Battery, (1) Battery Door Security Screw (use is optional) (1) Wide Angle Door Viewer (peep hole) used to secure both units to the door. |
 |
| Installation of Door Intercom: 1. If you already have a viewer in your door, remove it. If no viewer hole, drill a 1/2" or 9/16” hole in the door at eye level. 2. Remove battery door and attach 9-volt battery. 3. Slide power wire on back of INSIDE UNIT through hole in door and gently pull and take up slack. 4. Place INSIDE half of door viewer into Inside Unit and insert into hole in door, as shown in diagram. 5. Plug together power wire from Inside Unit to wire of Outside Unit. 6. Place OUTSIDE half of door viewer into Outside Unit and BY HAND, screw door viewer together, Securing Both Intercom Units to the Door. IMPORTANT: Push ALL excess wire into the Opening in the BACK of the Outside Unit. There should be NO WIRE between the Intercom Units and the Door. Use any coin to tighten. Do Not Over Tighten. Operation of Door Intercom: Inside Unit- Press the "Push to Talk / Release to Listen" Bar to speak and release to listen. Adjust the Volume Control to desired level. When the green LED light turns to red, change battery. Outside Unit- Includes a Call Feature (Door Chime) and a Water Resistant Speaker Microphone. |
|
|
|
|
|
|
For
all your gate opener needs visit
Gate-opener.com
|
||||
|
|
© Copyright 1997-2007 Below-Retail.net 1-800-593-6095 Toll Free
|
